Using The Air Compressor - Wagan Tech 2509 Guide D'utilisation

600 Amp Battery Jumper

USING THE AIR COMPRESSOR

† WARNING: Check item to be inflated for manufacturer's recommended maximum inflation
pressure� Avoid over inflation� Most tires are properly inflated between 30-35 PSI� Some
truck and bicycle tires require 40 PSI or more�
To Inflate Tires
1. Remove valve cap from air valve stem. Note: Make sure locking thumb lever is in up
position. If necessary, use valve stem adapter.
2. Insert stem connector to valve stem. Make sure connector is pushed into valve stem as far
as possible.
3. Press down the locking thumb lever to engage.
4. Set the compressor on/off switch (located next to the pressure gauge) to "on" position by
pressing down the section of switch marked "I". Note: In the event that the tire is completely
flat, raise the vehicle using a recommended jack before inflating the tire.
5. Monitor tire pressure on air pressure gauge. Note: It is recommended to use a separate air
gauge to check the actual inflation pressure. When desired pressure is reached, turn off
compressor, turn the locking thumb lever to up position, and remove stem connector from
valve stem. Also remove valve stem adapter if applicable.
6. Replace valve cap on valve stem.
To Inflate Plastic Inflatable (balls, air mattresses, rubber rafts, etc.)
1. Check manufacturer's specifications on the item to be inflated for correct inflation pressure.
2. Remove valve cap cover from valve stem.
3. Insert proper valve stem adapter into stem connector as far as possible and turn the locking
thumb lever to down position.
4. Insert the other end of the valve stem adapter into inflatable air valve stem as far
as possible.
5. Set the compressor on/off switch (located next to the pressure gauge) to "I" position.
6. Monitor air pressure on pressure gauge meter. When desired pressure is reached, turn off
compressor, turn the locking thumb lever to up position, and remove stem connector from
valve stem. Also remove valve stem adapter if applicable. Replace valve cap on valve stem.
7
by Wagan Tech
™
www.wagan.com
®