iOnBoost
Slim by Wagan Tech
™
USB CHARGING
1. Plug the micro USB cable into the micro USB input port on the iOnBoost.
2. Plug the other end into a USB power source such as a USB wall charger or
computer (not included). For charging in your vehicle, use the included USB
vehicle adapter.
a. The blue battery status indicator lights will illuminate while the unit is
charging.
3. Fully charge the unit (around 2 hours). Charging is complete when all
battery status indicator lights illuminate solid.
4. When charging is complete, unplug the USB cable.
CHECKING BATTERY STATUS
1. Turn on the master switch
2. Wait 3 seconds
3. Press the Power button once
4. Turn off the master switch when finished.
JUMPSTARTER
JUMPSTART WARNINGS
Failure to follow these instructions may cause damage or explosion.
NOTE: Cranking an engine produces an accumulation of explosive gas above and
near the vehicle battery. Before any attempt to jumpstart a vehicle battery, make
sure explosive gas is dispelled from the area. Use a cardboard or newspaper fan
to wave the gases away from the battery for a few minutes. Do not use plastic or
metal sheet—they can produce sparks and ignite the gas.
5
®
www.wagan.com