Using The Dc Power Socket; Using The Usb Sockets; Led Flashlight; Proper Disposal - Wagan Tech IONBoost V10 Guide D'utilisation

USING THE DC POWER SOCKET

For proper and safe operation of the DC power socket, do not place anything into it except the
plug of the accessory to be used.
Overloading the port may result in "tripping" a self-resetting circuit breaker. Removing the
overload automatically restores power to the DC socket.
1. Insert DC plug of the accessory you wish to use. Power will be automatically supplied.
2. Do not use jumpstart feature while DC socket is in use.
3. Recharge the iOnBoost as soon as convenient.

USING THE USB SOCKETS

If the charge in the iOnBoost is low, the USB ports will shut off to prevent damage to
the iOnBoost.
1. Insert USB plug of the device you wish to charge.
2. Tap the button.
3. Do not use jumpstart feature while either USB socket is in use.
4. Recharge the iOnBoost as soon as convenient.

LED FLASHLIGHT

The light will automatically shut off before the iOnBoost runs out of power.
1. Hold down the
2. Press once to switch lighting modes: steady – flashing – SOS – off.
3. Recharge battery as soon as convenient.

PROPER DISPOSAL

• This product has no consumer serviceable parts.
• Do not attempt to remove or replace the battery used in this device. When
the battery has reached the end of its lifetime, please take the entire unit to a battery
recycling facility.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
button until the flashlight turns on (~3 seconds).
©2015 Wagan Corporation. All Rights Reserved.
11