Function - Franke AQCT0031 Notice De Montage Et De Mise En Service

11.12 Connect the AQUACONTACT sensor (d) with
– a battery compartment (e)
or
– a wall-mounted power supply unit (f).
☞
If the battery charge state is low, the LED flashes in a 20s cycle.
11.13 Remove the protective film from the shower panel.
11.14 Seal the shower panel (e.g. with Chromol, not part of the scope of delivery, see
Accessories, Chapter
11.15 Only for water connection from the rear: Prioritise work steps 11.17 to 11.19.
11.16 Mount the shower panel on the suspension rail and screw tight.
11.17 Establish the water connection.
11.18 Open the water volume regulator using a hexagonal wrench.
g: closed
h: open
11.19 Check the water connection for leaks.

12. Function

☞
You can switch between time control and body reflection using the remote control
(not in the scope of delivery; see Accessories,
Time control
Triggering the flow of water
12.1 Hold your hand near the sensor.
• The water will flow.
• The water flow will stop automatically
– once the preset flow time expires
or
– after approaching the sensor once again
or
– after leaving the sensor range.
☞
The flow duration is factory-set to 30 seconds.
Body reflection
Triggering the flow of water
12.2 Hold your hand near the sensor.
• The water will flow.
• The water stops automatically once you leave the range of the sensor or after
5 minutes, at the latest.
8
23).
info@hygiene-shop.eu - www.hygiene-shop.eu
Chapter 23).