ALFRA ROTABEST RB 35 SP Mode D'emploi page 15

Desciption
The magnetic core drilling machine can be attached to ferromagnetic work pieces using the installed mechanically
switchable permanent magnet. For this purpose, the magnetic lever must be pressed downwards and the safety
tab must latch into place correctly. The motor can be switched on and off using the large keys on the operator
panel. The machine is equipped with two LEDs: The magnet sensor LED on the housing indicates the operating
state of the motor and the magnet's holding force. The motor LED on the operating panel is used to control the
temperature of the motor and the state of the carbon brushes. A self-adjusting dovetail guide which the motor is
attached to can be vertically adjusted using the star handle. The type plate and an attachment possibility for the
Allen keys included can be found on the back of the machine.
A) Drive motor
B) Weldon quick-change tool holder
C) Slide and setting screws
for adjustment on the back
D) Magnetic base
E) Recess for safety belt
F) Mains cable
G) Safety tab
H) Operating panel
I) Lever for magnet
J) Star handle
1 – Motor ON
2 – LED for motor control
3 – Motor OFF
4 – Magnetic lever ON
5 – LED for magnetic field sensor
6 – Magnetic lever OFF
15