Default Settings; Handset Name - switel DE102 Mode D'emploi

12 Settings
12.1

Default settings

Language:

Handset name:

Handset ringer volume: 3
External ringing melody: 3
Internal ringing melody: 1
Base ringer volume:
Base ringing melody:
Receiver volume
PIN:
Dialling mode:
Recall time 1 (standard): 90 ms
Recall time:2
The handset and base station can be reset to their default settings.
Refer to Section 7 for the procedure to do this.
Please note that, on resetting the default settings, the entries in the phone book, calls
list and phone numbers in the redialling list are deleted!
12.2 PIN code
The PIN code can contain up to four digits. The default setting of the PIN code is "0000". If you
change a PIN code, keep a note of the new PIN code in a safe place.
12.3 Recall times
The recall time determines the duration of a tone which is produced by pressing a button on the
telephone. In order that your telephone system can function properly, it may be necessary to adapt
the recall time (flash time).
There are two recall times available for selection in order to use functions in private branch ex-
changes or supplementary services offered by your telephone network provider (also refer to Sec-
tions 2.7 and 2.9). You can select between a recall time of 90 ms (default setting) and 250 ms. The
procedure to set the recall times is described in Section 7 (also refer to section 12.1).
12.4 Handset name
An individual name can be programmed for the handset.
It can comprise up to 10 characters.
94
− Settings −
German
DE102
3
2
3
0000
Tone (DTMF)
250 ms
SMS receive centre 1:
SMS receive centre 2:
SMS send centre 1:
SMS send centre 2:
SMS receive signal:
Low battery warning:
Out of range warning:
Key beep:
Key lock:
Automatic answer:
Time / Alarm:
Pause:
* Swisscom" service centre
0622100000*
Empty
0622100000*
Empty
On
On
OFF
On
OFF
On
OFF
3 seconds