Causes And Operator Prevention Of Kickback - Parkside PKSA 40-Li A1 Traduction Des Instructions D'origine

GB IE
protection. Other protective
equipment for the head, hands,
legs and feet is compulsory. Ad-
equate protective clothing will reduce
personal injury by flying debris or ac-
cidentaI contact with the saw chain.
• Do not operate a chain saw in a
tree. Operation of a chain saw white
up in a tree may result in personal in
jury.
• Always keep proper footing
and operate the chain saw only
when standing on fixed, secure
and level surface. Slippery or un-
stable surfaces such as ladders may
cause a loss of balance or control of
the chain saw.
• When cutting a branch that is
under tension be alert for spring
back. When the tension in the wood
fibres is released the spring loaded
Iimb may strike the operator and/or
throw the chain saw out of control.
• Use extreme caution when cut-
ting brush and saplings. The slen-
der material may catch the saw chain
and be whipped toward you or pull
you off balance.
• Carry the chain saw by the
front handle with the chain saw
switched off and away from
your body. When transporting
or storing the chain saw always
fit the guide bar cover. Proper han-
dling of the chain saw will reduce the
Iikelihood of accidentaI contact with
the moving saw chain.
• Follow instructions for lubri-
cating, chain tensioning and
changing accessories. Improperly
tensioned or lubricated chain may
either break or increase the chance for
kickback.
• Keep handles dry, clean, and
40
free from oil and grease. Greasy,
oily handles are slippery causing loss
of control.
• Cut wood only. Do not use chain
saw for purposes not intended.
For example: do not use chain
saw for cutting plastic, masonry
or non-wood building materials.
Use of the chain saw for operations
different than intended could result in a
hazardous situation
Causes and operator
prevention of kickback
Beware of kickback! Be careful of
kickback of the machine during
work. There is danger of injury
here. You can avoid kickbacks by
exercising caution and using a cor-
rect sawing technique.
Fig. 1
• Kickback may occur when the nose or
tip of the guide bar touches an object,
or when the wood closes in and pinch-
es the saw chain in the cut (cf. image
1/fig. B).
• Tip contact in some cases may cause
a sudden reverse reaction, kicking the
guide bar up and back towards the
operator (cf. image 1/fig. A).
• Pinching the saw chain along the top
of the guide bar may push the guide
bar rapidly back towards the operator.
• Either of these reactions may cause
you to lose control of the saw which
could result in serious personal injury.