Maintenance And Cleaning; Cleaning; Maintenance Intervals - Parkside PKSA 40-Li A1 Traduction Des Instructions D'origine

GB IE
Maintenance and

cleaning

Maintenance and cleaning

work must always be carried
out with the motor switched
off and the batteries re-
moved. Danger of injury!
Leave any maintenance and
servicing work not covered
by this manual to our Ser-
vice-Center. Use only original
spare parts.
Allow the machine to cool
down before all maintenance
and cleaning works. Danger
of burn injuries!
Use cut-protection gloves
when handling the chain or
the chain bar. Risk of cuts!
Switch off the device and remove
the battery before carrying out any
maintenance work.
Maintenance Interval Table
Machine part
Components of
the chain brake
Sprocket chain
wheel (20)
Saw chain (6)
Guide bar (7)
Guide bar (7)
Automatic oil
system
50
Action
Check, replace if required
Check for wear/indentations,
replace if necessary
Check oil, regrind or replace
if required
Check, clean and oil
Turn around
Check, clean oil aperture if
necessary
Cleaning
• Clean the machine thoroughly after
every use. In this way, you extend the
life of the machine and avoid accidents.
• Keep the gripping handles free of pet-
rol, oil or grease. Clean the gripping
handles, where appropriate, with a
moist cloth soaked in soap. Use no sol-
vents or petrol for cleaning!
• Clean the saw chain after every use.
Use a paint brush or wipe for that. Do
not use any liquids to clean the chain.
After cleaning, oil the chain lightly with
chain oil.
• Clean the ventilation slots and the
surfaces of the machine with a paint
brush, whisk or dry cloth. Do not use
any liquids for cleaning.

Maintenance intervals

Regularly carry out the maintenance opera-
tions listed in the following table. The life
of the saw is extended by regular main-
tenance of your chainsaw. Furthermore,
you get optimum cutting performance and
avoid accidents.
Before every
use





After 10 hours
of operation
