Troubleshooting
The following checklist will help you solve problems you may encounter with your
unit.
Before going through the checklist below, check the connection and operating
procedures.
General
No picture
Good picture, but no sound
Dotted lines or stripes
No picture when you connect
the optional equipment.
No response when pressing
the buttons on the card
remote commander
No picture even when playing
back the connected device
while driving.
The operation buttons on the
monitor do not function. / The
monitor does not turn off. /
Nothing but the white
background appears on the
display.
•The power cord has been disconnected.
•The fuse has blown.
Press (VOL)(+) ((VOLUME)(+) on the monitor) or (ATT) on
the card remote commander.
This may be caused by local interference such as a car
engine or motorcycle. Adjust the antennas for minimum
interference.
The cord has been disconnected. Connect the cord securely.
The battery may be exhausted.
The FRONT/REAR switch is switched to "FRONT". If you
use the monitor on a dashboard, you can use only NAVI as
an input source while driving. Playback the connected
device when the car is stopped.
Remove the monitor from the cradle to stop the power
distribution, and press the (RESET) button on the rear side
of the monitor with a pointed object, such as a ballpoint pen
(page 8).
19