Bartscher 110.110 Mode D'emploi page 27

•
Fasten two nuts, angles for the glass plate, sealing rings and screws.
•
Check that the right, left and rear glass plates are tightly secured.
•
Place the upper glass plate on the right, left and rear glass plates.
•
Fasten it using the seven nuts, sealing rings and screws.
•
Check that all glass plates are firmly secured.
Installation
•
Place the device on a flat, secure surface that can support its weight.
•
Never place the device on a flammable surface (e.g. carpet).
•
Do not place the device near an open flame, electric ovens, coal furnaces or other
sources of heat such as direct sunlight. High temperatures may have a negative
effect on cooling power and increase energy consumption.
•
Place the device so as to allow proper air circulation. Keep a minimum distance of 5 cm
from the rear, 10 cm at the sides and 30 cm from the ceiling or shelves.
•
Never cover the device's ventilation ducts.
•
Do not place the device where high levels of ambient humidity occur. Such high
humidity may damage the device.
C onnection
•
If the device has been transported in an upright position, wait 2 hours prior to
connecting the device (integrated condenser) to a power source.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
- 26 -