Asko CI41236S Mode D'emploi page 15

INSTALLATION
A
Fig.1
- Unpack the frame and remove the two
screws A to separate the top section from
the bottom section (Fig.1).
A
Fig.3
For assembly, screws should be used that
are suitable for the wall type (for example
reinforced concrete, plasterboard, etc.).
If screws and plugs are supplied with the
hood, make sure in advance that these are
suitable for the wall on which the hood is to
be installed.
This hood could be heavy, therefore we advise to install this hood
with at least two people.
A
Fig.2
- Take the template and
place this against the ceiling with the arrow
on the same side as the hood's control panel
(Fig.2).
C
B
Fig.4
- Drill four holes Ø 8 in the ceiling and affix the
four plugs.
- Form the air outlet opening A (Fig.3).
- Connect the tube to the opening A.
- Take the bracket B and secure this to the
ceiling with the four screws C (Fig.4).
EN 15