Hitachi DS 12DVF3 Instructions De Sécurité Et Mode D'emploi page 22

English
CAUTION:
The motor rotation may be locked to cease while the unit is used as drill. While
operating the driver drill, take care not to lock the motor.
When setting the shift knob to "HIGH" (high speed) and the position of the clutch dial
is "17" to "22", it may happen that the clutch does not engaged and that the motor is
locked. In such a case, please set the shift knob to "LOW" (low speed).
If the motor is locked, immediately turn the power off. If the motor is locked for a while,
the motor or battery may be burnt.
Too long hammering may cause the screw broken due to excessive tightening.
A buzzing noise is produced when the motor is about to rotate; This is only a noise, not
a machine failure.
THE SCOPE AND SUGGESTIONS FOR USES
Work
Wood
Drilling Steel
Aluminum
Machine
screw
Screw
tightening
Wood
screw
22
Table 3
Clutch dial position
1 – 22
1 –
Suggestions
Use for drilling purpose.
Use the bit and socket matching the
screw diameter.
Use after drilling a pilot hole.