Makita HP2010N Manuel D'instruction page 5

CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
Speed change
1
002853
Two speed ranges can be preselected with the speed
change lever.
To change the speed, press the speed change lever and
slide it to the "L" position for low speed or the "H"
position for high speed. If the speed change lever does
not slide easily, turn the chuck slightly in either direction
while sliding the lever.
Be sure that the speed change lever is set to the correct
position before operation. Use the right speed for your
job.
CAUTION:
Always set the speed change lever fully to the
•
correct position. If you operate the tool with the
speed change lever positioned halfway, the tool
may be damaged.
Do not use the speed change lever while the tool is
•
running. The tool may be damaged.
Selecting the action mode
002854
This tool has an action mode changing ring.
For rotation with hammering, turn the ring in the direction
of multiple arrow indication.
For rotation only, turn the ring in the direction of single
arrow indication.
1. Change lever
1. Change ring
1
CAUTION:
Always turn the change ring fully to your desired
•
mode mark. If you operate the tool with the ring
halfway, the tool may be damaged.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (auxiliary handle)
002458
Always use the side grip to ensure operating safety.
Install the side grip on the tool barrel. Then tighten the
thumb screw securely at the desired position. It may be
swung 360° so as to be secured at any position.
Installing or removing drill bit
002435
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.
Depth gauge
1
002439
5
1. Chuck key
1
1. Depth gauge
2. Clamp screw
2