Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Initial Settings
Adjusting the brightness
You can adjust the display brightness. Initially
this mode is set to 12.
1
Use MULTI-CONTROL to select
Brightness.
Brightness appears in the display.
2
Push MULTI-CONTROL left or right to
adjust the brightness level.
Each time MULTI-CONTROL is pushed left or
right, brightness level increases or decreases.
00 to 15 is displayed as the level is increased
or decreased.
# When dimmer is functioning, the brightness
level can be adjusted 00 to 10.
Selecting the illumination
color
This unit is equipped with two illumination col-
ors, white and blue. You can select the desired
illumination color.
1
Use MULTI-CONTROL to select
Illumination.
Illumination appears in the display.
2
Press MULTI-CONTROL to select the de-
sired illumination color.
Pressing MULTI-CONTROL repeatedly will
switch Illumination between white or blue
that status will be displayed (e.g., Blue).
Correcting distorted sound
When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1
Use MULTI-CONTROL to select
Digital ATT.
Digital ATT appears in the display.
2
Press MULTI-CONTROL to select the di-
gital attenuator level.
Pressing MULTI-CONTROL repeatedly will
switch between High (high) and Low (low)
and that status will be displayed.
Resetting the audio functions
You can reset all audio functions.
1
Use MULTI-CONTROL to select
Audio Reset.
Reset OK! appears in the display.
2
Press MULTI-CONTROL.
Does it RESET? appears in the display.
3
Push MULTI-CONTROL right.
Are you sure? appears in the display.
4
Press MULTI-CONTROL to reset audio
functions.
Complete appears in the display and audio
functions are reset.
# To cancel this function on the way, press
BAND.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
Section
14
73
En
Publicité
Chapitres
Table des Matières
