Adjusting The Time Alignment; About The Network Function - Pioneer DEH-P880PRS Mode D'emploi

Audio Adjustments
Initial (initial)—Custom (custom)—Auto TA
(auto-time alignment)—TA OFF (off)
! Initial is the factory supplied time align-
ment.
! Custom is an adjusted time alignment that
you can create for yourself.
! Auto TA is the time alignment created by
auto TA and EQ. (Refer to Auto TA and EQ
(auto-time alignment and auto-equalizing)
on page 68.)
# Please set Auto TA appears. This indicates
that you cannot select Auto TA if auto TA and EQ
has not been carried out.

Adjusting the time alignment

You can adjust the distance between each
speaker and the selected position.
! An adjusted time alignment is memorized
in Custom.
1 Use MULTI-CONTROL to select TA 1.
TA1 appears in the display.
2 Press MULTI-CONTROL to select a unit
of distance.
Each press of MULTI-CONTROL selects the
unit of distance in the following order:
(cm) (centimeter)—(inch) (inch)
3 Use MULTI-CONTROL to select TA2.
TA2 appears in the display.
# Can't Adjust TA. Set POS FL/FR appears
when neither Front Left nor Front Right is se-
lected in the position selector mode (POSI).
# When selecting TA OFF in TA1, you cannot
switch to TA2.
4 Push MULTI-CONTROL left or right to
select the speaker to be adjusted.
Each time MULTI-CONTROL is pushed left or
right, the speaker is selected in the following
order:
Hi L (high-range left)—Hi R (high-range right)
—Mid L (middle-range left)—Mid R (middle-
range right)—Low L (low-range left)—Low R
(low-range right)
Front L (front left)—Front R (front right)—
Rear R (rear right)—Rear L (rear left)—
SubW. L (subwoofer left)—SubW. R (subwoo-
fer right)
# You cannot select SubW. L and SubW. R
when the subwoofer output is off.
5 Push MULTI-CONTROL up or down to
adjust the distance between the selected
speaker and the listening position.
Each time MULTI-CONTROL is pushed up or
down, the distance increases or decreases.
400.0cm to 0.0cm is displayed as the distance
is increased or decreased, if you have selected
centimeters ((cm)).
160inch to 0inch is displayed as the distance
is increased or decreased, if you have selected
inches ((inch)).
# You can adjust the distance for the other
speakers in the same way.
6 Press BAND to cancel the time align-
ment mode.
About the network
function
The network function lets you divide the audio
signal into different frequency bands, and
then reproduce each of them through sepa-
rate speaker units.
Section
13
59
En