toolport 8 m professional Série Mode D'emploi page 28

8 m series
GB
Instructions
Select a flat surface for the tent. Unpack the boxes and check if all listed parts are included.
with a cloth. Remove the slight oil film from the pipes with a cloth. In colder weather
conditions we suggest to bring the roof to room temperature before installing.
1
Assemble the roof frame by mounting parts 7 to 12 on the pipes (parts 2 and 3).
Use the screws (29 and 30) to attach the parts.
2
Attach the reinforcement braces (parts 4 and 5) using screws (28) and wing nuts (31).
Fastening the roof by using turnbuckle set (18) which is diagonally across through each two
section as below.
3
Lift one side of the tent frame and attach the legs (6). Place the roof (34) onto the frame and
use the bungees (23) to fasten it. Be sure not to put too much tension on the bungees in order
not to make attaching the other side more difficult.
4
Attach the legs (6) on the other side and install the feet (13, 14 and 15) at the bottom. Attach
the side covers to the pipes (1) using hooks (26). Make sure, that the leg pipes are in
vertical position, to avoid overtention on the endwalls. Using turnbuckle sets (17) to fasten the
structure just the same as you do on roof. Complete the bottom frame with the required pipes
(2) and connector (13, 14, 15 and 16).
5
Unfold the side walls (35) and the end walls (36) and attach the side walls to the frame using
the bungees (23). Attach the endwalls directly to the roof using the short bungees (24).
Use the short ground pegs (22) to fasten the end walls to the ground. The guy rope runs from
every corner of the tent and is braced to the ground using the screw hooks (20). The professional
ground pegs (19) provide the tent with additional tension and stability.
professional
28