Twin Needle Setting, Mirror/ Reverse Stitch And Elongation - Singer 9940 Notice D'utilisation

C. TWIN NEEDLE SETTING, MIRROR/
REVERSE STITCH AND ELONGATION
You can change the settings of twin needle,
reverse, mirror and elongation stitches.
To make changes, press the mode button (f).
The upper arrow mark (l) on the right side of LCD
will be highlighted. At this condition, twin needle
setting, reverse, mirror stitch and elongation can
be changed.
By pressing the mode button (f), mode will change
alternately and it is indicated by highlighted arrow
on the right side of LCD.
m.Twin needle setting
Press function button directly under the twin
needle mark. Prssing this button, width setting
will change altenately. See page 76 for twin
needle sewing.
m-1: Single needle setting (Regular setting)
m-2: Twin needle setting
When you select this mode, it remains until you
turn off the machine.
n. Mirror/reverse stitch
You can set the mirror stitch, or reverse stitch
or mirror/reverse stitch.
Pressing the function button directly under this
mark, stitch will change alternately or in
rotation.
The mark on the LCD indecates the selected
stitch as follows:
n-1. Regular stitch (normal stitch)
n-2. Mirror stitch (reverse left and right)
n-3. Reverse stitch (reverse front and back)
n-4. Mirror and Reverse stitch
If the mark is not indicated, the pattern cannot
change to mirror or reverse stitch.
o. Elongation
You can elongate the pattern to two times the
length.
By pressing the function button directly below
the elongation mark.
o-1: Regular length
o-2: Elongated (2 X)
If the mark is not indicated, its pattern can not
elongate.
40
9940EFSt.pm6
40 2003.9.10, 8:31 PM