Installing The Monitor; Pairing The Monitor With The Electronic Control Box; User Guide - Extel LESLI Guide D'installation Et D'utilisation

Caution: do not touch the electronic circuit directly (see note in the safety instruction section)
5. Using 2 screws, fix the control box using the 2 holes located at the top and bottom, the aerial being at the top
right (fig. 6).
6. Remember to first pass the outside station connecting wire through the hole in the pillar plus 2 wires (Fig1-8)
for the connection to the door opener (you should therefore drill the pillar or wall accordingly). These 2 wires
are then connected to the electric lock or door opener and on the "LOCK" terminal block in the electronic
control box.
Note: Do not install any aerial other than the original one
Caution: you should never install the batteries before having fully completed the installation
... or to the mains
If the electronic control box is supplied using an external power source
from a WETR 14602 SER.R1 type transformer, or from an automatic portal (12 or 24 V AC/DC). It must be con-
nected to the ~ - and ~ + terminals on the electronic control box. When using DC voltage, take care to respect
the polarity (- +). (see 7 fig.4)
If you are using an external 12/24 V AC/DC power source, the batteries must be removed.
Then close the control box top cover and replace the 6 screws. (fig.5)
b. Installing the monitor ...on a wall
1. Drill two holes in the wall corresponding to the holes at the back of the monitor base. We suggest fixing the
monitor at least at 1.6 metres from the ground.
2. Insert 1 anchor in each hole and then 1 screw in each anchor.
3. Connect the mains adapter to the DC IN socket.
4. Fold the screen onto the monitor base. Lock the screen in position by inserting the metal loop onto the 2 clips
in one of the 2 possible positions.
5. Fix the aerial onto the SMA connector. It must point upwards.
6. Attach the screen base to the wall and connect the power supply adapter to the power outlet. The monitor is
now ready for use.
... or on a desktop
1. Lock the screen in position by inserting the metal loop onto the 2 clips in the selected position.
2. Fix the aerial onto the SMA connector. It must point upwards.
3. Connect the mains adapter to the mains. The monitor is now ready for use.
c. Pairing the monitor with the electronic control box
• By default, the monitor and the outside station are paired on CH1 in the factory.
• If the monitor is replaced, select CH1 and press "PAIR" to start the pairing process, press the call button on
the outside station. y ou have 30 seconds to press the pairing key on the electronic control box (Fig4-8). The system
confirms the result by displaying "PAIRED" or "PAIRING FAILED". (see section 6a)

5. uSER GuIDE

Caution: If you test your videophone before installing it (short distance test) keep a minimum distance between
the monitor and the outside station of about 3 m (risk of saturation) Also place the monitor on a level surface.
CFI EXTEL LESLI - 01/2015
GB4