Pc Communication; Snmp - Sony SRX-R110 Manuel D'installation

Account Name: Enter the user name to log in to the
SMTP server.
Password: Enter the password of the user to log in to
the SMTP server.
Send Test Mail: Selects whether you send a test mail.

PC Communication

The PC Communication window is used to configure for
communication between the projector and the computer
for controlling the projector.
Projector Identifying
Configures the projector.
Port No.: Enter the UDP port number.
Interval: Enter the interval at which the IP packets are
sent.
Broadcast Address: Enter the broadcast address.
: Registers the entered IP address in the list.
: Deletes the IP address from the list.
List box: Displays the registered broadcast addresses.
Controlling PC Destination
Configures the computer for controlling the projector.
Port No.: Enter the TCP port number.
Time-out: Enter the time when the communication is to
end.
Accept Connections from these hosts: Enter the IP
address of a host who is allowed to access the
projector.
: Registers the entered IP address in the list.
: Deletes the registered IP address from the list.
List box: Displays the registered IP addresses of the hosts
allowed to access the projector.
Network Block Reboot
Restarts the Network CPU after the PC Communication
settings complete. Click the REBOOT button to restart.
12
GB
Setting Up the Projector

SNMP

The window is used to set up SNMP (Simple Network
Management Protocol).
SNMP
sysName: Enter the characters for the standard MIB
sysName.
Contact: Enter the characters for the standard MIB
sysContact.
Location: Enter the characters for the standard MIB
sysDescr.
Send authentication trap: Selects when you permit
sending authentication trap.
Accept SNMP packet from any host: Selects when you
permit access to the projector from any host.
Accept SNMP packets from these hosts: Selects when
access to the projector is allowed for specified hosts
only. Enter the IP address of the host permitted to
access the projector in the text box.
: Register the entered IP address in the list.
: Deletes the registered IP address from the list.
List box: Displays the registered IP addresses of the
hosts allowed to access.
Community: Selects and edit the community name.
Add button: Click to add the selected community name.
Edit button: Click to enter edit mode for attributes of the
selected community.
Remove button: Click to remove the selected community.
Community Name: Clicking the Edit button displays the
community name whose attributes can be edited, and
the following items are activated:
Rights: Selects the access right.
Set to List button: Click to apply the change of
attributes.
Cancel button: Click to cancel the change of
attributes.
Trap Destinations: Enter the IP address of a host for
trap destination.
: Register the entered IP address in the list.
: Deletes the registered IP address from the list.
List box: Displays the registered IP addresses of the
hosts for trap destination.