Elica ELI136SS Guide D'utilisation, D'entretien Et D'installation page 8

• Attach the lower horizontal support to the hood with
8 - 4.2 x 8mm screws.
• Attach the middle horizontal support to the hood with
8 - 4.2 x 8mm screws.
• Attach the 4 upper vertical supports to the hood with
16 - 4.2 x 8mm screws.
• Attach the assembly to the support fixed on the ceiling.
Assure it with 16 - 4.2 x 8mm screws.
Mounting the
range hood blower
1. Slide the rear mounting plate flange under the bracket.
B. Blower mounting plate
2. Push the front end of the mounting plate up and snap into spring
tab.
NOTE: The spring tab should be outside of the slot in the mounting
plate.
A. Blower mounting plate
8
A
A. Bracket
B
A
B. Spring tab
B