Range Hood Care - Elica ELI136SS Guide D'utilisation, D'entretien Et D'installation

Range hood care

Replacing an Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To avoid
damage or decreasing the life of the new lamp, do not touch lamp
with bare fingers. Replace lamp, using tissue or wearing cotton gloves
to handle lamp. If new lights do not operate, make sure the lamps are
inserted correctly before calling service.
1. Disconnect power.
2. Use a flat-blade screwdriver and gently pry the light cover loose.
3. Remove the lamp and replace with a 120-volt, 40-watt
maximum, halogen lamp made for a G-9 base.
4. Replace the light cover.
5. Reconnect power.
6. Turn the light switch to the "OFF" position to turn the range hood
lights Off.
Cleaning
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads. Rub in direction of the grain line to avoid
scratching the surface.
Always wipe dry to avoid water marks.
■
Stainless Steel Cleaner and Polish.
■
Mild liquid detergent and water.
■
Wipe with damp soft cloth or non abrasive sponge, then rinse
with clean water and wipe dry.
Metal Filters and Drip Trays:
1. Use 2 hands to remove filters.
2. Grasp filter handles, pull toward the front of range hood and pull
down on the rear handle to remove. Repeat for each filter.
A
3. Remove grease drip tray.
A
4. Wash metal filters and grease trays as needed in dishwasher or
hot detergent solution to clean.
5. Replace grease drip tray.
6. Reinstall filters, grasp filter handles and place front edge of filter
into the hood.
7. Push up on the back handle and set rear of filter into the drip tray
to secure. Repeat for each filter.
A
11
A. Grease filter
A. Drip tray
A. Grease filter