Blaupunkt TSA 460 Guide D'utilisation page 9

Use cable grommets to protect cables
against sharp-edged holes.
Use loudspeakers with an impedance of
Ω
2-4 . Observe the maximum load rating
(music power rating).
Use loudspeaker connecting cables up to
2
2.5 mm . Do not connect loudspeakers to
earth – only use the correct terminals as in-
dicated.
The cross section of the positive and
negative cables must be at least 6 mm
The positive cable between the battery
and the amplifier must be protected di-
rectly at the battery using a fuse holder
(50 amperes).
Removing the outer housing
(see Fig. 3)
1. Undo the cover's screw (A) that is locat-
ed above the switches and controls. Af-
terwards, lift the cover and carefully re-
move it.
2. Undo the four screws (B) that secure the
top half of the housing shell and then re-
move the top half of the housing.
3. Undo the six screws (C) that secure the
underside of the housing and then take
the amplifier out of the bottom half of the
housing shell.
Class D 4/3/2 Channel Amplifier
TSA 460
The amplifier is suitable for connection to car
radios that are equipped with RCA connec-
tions.
If you want to connect it to car radios that
are equipped with an ISO connection, please
use the Blaupunkt ISO-RCA adapter.
Usage options and loudspeaker connec-
tion:
Channels
Max. power
4 ohms
Max. Power
2 ohms
RMS power
4 ohms
2
.
RMS power
2 ohms
Frequency
response
Signal-to-noise
ratio
Input sensitivity
Stability
Low pass filter
(Low Pass)
High pass filter
(High Pass)
Subsonic filter
Dimensions
WxHxD (mm)
Inner housing
Outer housing
Positive/negative connection
The cross section of the positive and
negative cables must be at least 6 mm
Use cable grommets to protect cables
against sharp-edged holes. Securely
screw a standard 6 mm
to an interference-free earth connection
point (bolt connected to the car body, car
body sheet metal) – though do not con-
nect it to the negative terminal of the bat-
tery. Scratch the surface down to the bare
metal at the point at which the earth con-
tact is made and apply graphite grease.
TSA 460
TSA 460
4/3/2
4 x 120 watts /
2 x 300 watts
4 x 180 watts
4 x 60 watts /
2 x 150 watts
4 x 90 watts
20 - 20000 Hz
> 95 dB/A
0.3 - 8 V
2 ohms
50 - 250 Hz
50 - 250 Hz
20 Hz, switchable
205 x 45 x 177
253 x 67.5 x 210
2
negative cable
Fig. 7,
8, 9
Fig. 7,
9
Fig. 7,
8, 9
Fig. 7,
9
2
.
9