Initial Use; Removing The Air Cleaner; Setting Up The Air Cleaner - Beurer LR 300 Mode D'emploi

Display and buttons
1
1 ON/OFF button
Switches the device on/off
2 AUTO button
Activates the automatic function (fan speed auto-
matically adapts to the ambient air quality and the
LED is lit continuously). If the light below "Replace
Filter" is flashing, change the filter. After changing
the filter, hold down the AUTO button to reset the
automatic counter for the filter change.
3 FAN SPEED button
The air cleaner has three fan speeds:
(medium) and

5. Initial use

5.1 Removing the air cleaner

1. Open the cardboard packaging.
2. Remove the device from the top of the box without opening the film bag.
3. Now remove all plastic films. Remove the combi filter from the device (see "Filter change" section) and
take it out of the plastic film. Then re-insert the combi filter into the device.
4. Check the device, mains plug and cable for damage.

5.2 Setting up the air cleaner

1. Place the air cleaner on a firm, level surface to prevent vibrations and noise.
IMPORTANT
If you wish to reposition the air cleaner, only carry it by the handle on the rear of the device.
2. Set up the air cleaner in such a way that provides 30 cm clearance on all sides.
3. Make sure that the air inlet and air outlet are never blocked.
2
3
(low),
(high).
4
4 UV-C light button
Switches the UV-C light on/off
5 TIMER button
The air cleaner features a timer function that you
can use to determine the number of hours the
air cleaner should run for before it automatically
switches itself off. The air cleaner has three timer
periods: 2H (two hours), 4H (four hours) and 8H
(eight hours).
16
5