Initial Use; Operation - Beurer LW 220 Mode D'emploi

5. Initial use

Remove the transport lock
• Open the cardboard packaging.
• Keep the plastic covering closed and lift the device out using the handle recesses on the upper cover.
• Now remove all plastic films.
• Check the device, mains plug and cable for damage.
• Lift off the upper cover with the fan unit, lift out the humidification discs at the holder and remove the
transport lock from the tub and the fan unit. Check whether all transport locks have been removed.
• Reinsert the humidification discs. The holder automatically falls to the side and the humidification discs
are secured. Make sure that the red spot is on the top of the holder.
Fill with water
• When filling with water, disconnect the plug from the mains.
• To fill the tub, lift out the upper cover with fan unit by the side handle recesses and place to one side.
• During filling, leave the humidification discs in the tub. Fill the tub with fresh, cold tap water at most up
to the lower edge of the "MAX" marking (7.2 l) on the inside of the tub. The most straightforward way to
do so is to use a large container free of limescale and impurities (water can, jug). Use only fresh, cold tap
water. For optimum humidification output, we recommend filling the tub with water up to the "OPT" mark
(3.6 l).
• Place the upper cover with integrated fan unit on the tub. If the upper cover cannot be placed precisely
onto the tub, turn the upper cover around by 180 degrees. This is a design feature and ensures that the
fill level sensor contacts touch each other. Never use force to place the upper cover on the tub. Otherwise
the device will be damaged.
Note:
Optionally, you can add a small amount of soluble aromatic oils to the water. This releases a fragrance
into the air.
Important
• Ensure the water level in the tub with inserted humidification discs never exceeds the lower edge
of the "MAX" marking on the inside of the tub.
Tip: The addition of a small volume of conventional washing-up liquid (e.g. 1 drop) breaks the water
surface tension and increases evaporation output.
Positioning the device
• Place the humidifier on a firm, even, water-resistant surface.
• Position the air washer in the vicinity of a heater to improve evaporation, in particular in large rooms
(do not exceed a max. temperature of 50 °C). Always ensure that the air inlet and air outlet remain clear
and that the air flows freely.
• Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard. You can clamp
the mains cable in the vertical ridge on the rear of the tub and lead it downwards.

6. Operation

Switch on the device using the On/off button
fan level 0 and the water fill level.
Select the fan speed using the fan button in the centre of the upper side.
Graphic displayed Fan level
Level 0, standby – fan off
Level 1, low
in the centre of the upper cover. The display lights up, shows
14