Initial Use; Removing The Air Purifier; Setting Up The Air Purifier; Preparing For The Application - Beurer LR 330 Mode D'emploi

6. Initial use

6.1 Removing the air purifier

1. Open the cardboard packaging.
2. Remove the device from the top of the box without opening the film bag.
3. Now remove all films and the transport lock of the disc set (in the tray). Ensure that you remove all the
foam padding from the disc set. Remove the combi filter and prefilter from the filter cover. Then remove
the plastic film and re-insert the combi filter and prefilter.
4. Check the device, tray with disc set, mains plug and cable for damage.

6.2 Setting up the air purifier

1. Place the air purifier on a firm, level and water-resistant surface to prevent vibrations and noise.
2. Set up the air purifier in such a way that provides 30 cm clearance on all sides.
3. Make sure that the air inlet and air outlet are never blocked.

6.3 Preparing for the application

1. Remove the top housing cover.
2. Carefully pull out the water tank from above.
3. Unscrew the seal on the water tank. Fill the water tank right to the top (approx. 4.6 l) with fresh, cold tap
water.
4. Close the water tank again. Ensure that the screwed plug is screwed on correctly and the water tank is
sealed shut.
5. Carefully place the water tank back into the housing from above.
6. Replace the top housing cover back onto the housing.
7. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.
IMPORTANT
Do not add any essential oils or fragrances to the water tank and/or the tray. If other additives are used, the
plastic material may become discoloured and damaged.
Tip: The addition of a small volume of conventional washing-up liquid (e.g. 1 drop) breaks the water surface
tension and increases evaporation output.
Step 1: remove top cover
Step 2: remove water tank
19