Makita WT01 Manuel D'instruction page 6

Reversing switch action
1
011764
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
Installing or removing socket
1
2
011765
To install the socket, push it onto the anvil of the tool until
it locks into place.
To remove the socket, simply pull it off.
1. Reversing
switch lever
1. Socket
2. Anvil
6
OPERATION
011766
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
N . m
(ft . lbs)
Standard bolt
80
(58)
60
(43)
40
(29)
20
(14)
0
1.0
Fastening time (S)
011825
N . m
High tensile bolt
(ft . lbs)
80
(58)
60
(43)
40
(29)
20
(14)
0 1.0
Fastening time (S)
011823
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
NOTE:
When fastening screw M8 (5/16") or smaller,
•
carefully adjust pressure on the switch trigger so
that the screw is not damaged.
M12(1/2")
M12(1/2")
M10(3/8")
M8(5/16")
M10(3/8")
M8(5/16")
2.0
M10(3/8")
M10
(3/8")
M8(5/16")
M8
(5/16")
M6(1/4")
M6
(1/4")
2.0
3.0
3.0