Saeco MEGACOLD S Notice Originale page 76

MEGACOLD S/M – Issue 01
The character with the 00 code moves the cursor forward by one position.
CAUTION! : If the cursor is on the other side of the first character of the message and you press the ESC key
to return to the main menu, the message is cut off at the point which corresponds to the position of the
cursor; therefore before quitting, make sure that the cursor is moved to the end of the message.
It is advisable to prepare the message on a piece of paper using the codes in the table (spaces included) and
then enter it in the machine.
Command 99 View error events:
This command displays the last 20 error events; to go from one display to another press the B key. At the end
of the display, the system asks the user to confirm the clearing of all the data. Press ENTER to confirm or
ESC to leave the records as they are.
ERROR
CODE
01 Number selection code
02 Number selection code
05 Number selection code
09 Number selection code
10
11
16 (*) 33 - 38 - 39
17
18
30
31
32÷38
39
51
55
61 Number selection code
62 Number selection code
65 Number selection code
69 Number selection code
91 Number selection code
( ) Key:
*
33 = Photocells
38 = Spirali Master
39 = Spirali Slave
SUB-CODE
Motor blocked (the spiral does not rotate)
The spiral does not complete the rotation
Motor disconnected
Possible microswitch defect or spiral motor wiring defect
(*) 38 - 39 Internal temperature feeler faulty
(*) 38 - 39 Evaporator probe faulty
Error communication with peripheral (a board for the electric
panel)
Communication break during sale cycle without credit
(*) 38 - 39
collection
(*) 38 - 39 Communication break during sale cycle with credit collection
(*) 38 - 39 Fridge safety has intervened
(*) 38 - 39 Photocell test error .
(*) 38 - 39 Photocell calibration error
(*) 38 - 39 photocell safety
Interruption of peripheral connection at the beginning of the
(*) 38 - 39
sale cycle.
/ Payment system out of service.
Motor blocked (the spiral does not rotate) SLAVE
The spiral does not complete the rotation SLAVE
Motor disconnected SLAVE
Possible microswitch defect or spiral motor wiring defect
SLAVE
Selections not reset.
FAILURE
31
E
N
G
L
I
S
H