Bosch SHXM63WS5N Notice D'utilisation page 32

en-us Operating the Dishwasher
Cancel a cycle (Reset)
Open the door and press and
1.
hold Start button P for
approximately 3 seconds until the
display reads ‹:‹‚, then close
door again.
Wait about 1 minute while the
2.
dishwasher drains.
Open the door and press the
3.
On/Off button (.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time may
increase slightly. (Caution if utensils
are delicate!)
This feature has two settings:
š:‹‹ Off
š:‹‚ On
To change the setting:
Open the door.
1.
Press On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates •:x (x can
be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
indicates the factory set value
•:‹...
Press function key # until the
5.
display 8 indicates the factory
set value š:‹‹.
Press function key 3 to switch
6.
the feature on š:‹‚ or off š:‹‹.
Press Start button P to save
7.
setting.
32
InfoLight
®
While the wash cycle is running, a
light spot shines on the floor under
the appliance door.
Do not open the appliance door until
the light point is no longer visible on
the floor.
If the appliance door is not
completely closed, the light spot
flashes*.
If the appliance is installed at
eye-level, with flush furniture front, the
light point is not visible.
In darkened rooms, some light
scattering may be visible. This is
normal and cannot be changed.
You can switch the Infolight on or off.
Off
‚:‹‹
low
‚:‹‚
To change the setting:
Open the door.
1.
Press the On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates •:‹x (x can
be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
indicates the factory set value
•:‹...
Press the function key 3 to
5.
switch the InfoLight
‚:‹‚ or off ‚:‹‹.
Press Start button P to save
6.
the setting.
feature on
®