Maintenance
Cleaning (fig. W1)
Note: Remove switch key before cleaning or performing maintenance work. ttention: Keep hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or brush. Do not spray with water. Keep mower in a dry room.
Change of cutter blade (fig. W2)
Note: always disconnect mains supply and wear protective gloves before undertaking any workat the cutter blades, cutter bar
and blade coupling. Change cutter blade using 10 mm spanner as illustraded. Torque wrench setting for screws 8-10 Nm. Take care
to carry out this work thoroughly. Use original spare parts only. Note: Sharpining of blades should be done by an approved service
centre as the correct balance of the blade after sharpening is very important and ought to be checked by an expert.
Change battery
1. Remove key
2. Release catch and remove battery (fig. W3)
3. Insert replacement battery and engage catch (fig. W3)
Winter Storage:
Clean mower thoroughly before storing away. Never spray mower with water and do not store it in a wet or humid place. Have
your mower thoroughly checked once a yearby an approved Service Centre.
The Rechargeable battery must be charged prior to long periods of storage.
Faults and how to remedy
Problem
Uneven running, heavy vibrations
in the mower
Motor will not run
Poor mowing
Poor catching
When in doubt, always consult a WOLF service workshop.
Important: switch off the mower and disconnect the mains plug before inspecting, cleaning or working on the blades.
Guarantee terms
Please carefully retain the guarantee card completed by the seller, or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24months from the date of purchase. This guarantee is in accordance with
the relevant state of technology and the utilisation purpose / area of application. The consumer's statutory rights are not affected by
the following guarantee guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial sector or leasing business.
- Proper handling and observance of all information given in the operating manual, which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals.
- No unauthorised alteration of the design.
- Installation of original WOLF replacement parts / accessories.
- Presentation of the completed guarantee card and/or proof of purchase.
This guarantee does not extend to normal wear-and-tear on blades, blade mounting components or friction disks, V-belts/toothed
belts, running wheels/tyres, air filters, spark plugs and spark plug connectors. ny guarantee claim shall be immediately void in the
event of unauthorised repairs.
Faults and defects which can be traced to material or manufacturing faults will be rectified exclusively by our contracted workshops
(the seller has the right to remedy a defect) in your vicinity, or by the manufacturer if the latter is closer. ny claims going beyond the
provision of a guarantee are ruled out. There is no entitlement to a replacement. ny transport damage should be reported not to us
but to the shipper in question since, otherwise, any compensation claims vis-à-vis the shipper would be voided.
Possible cause
• Blades damaged
• Blades loose in the fastening parts
• Battery discharged
• Blades blocked
• Key not inserted
• Blunt blades
• Battery defective
• Blunt blades
• Catcher bag blocked
11
Remedy (X) by:
WOLF service
Yourself
workshop
X
---
---
X
---
X
---
X
---
X
X
---
X
---
X
---
---
X