Description And Operation; Safety - Vortice ARIETT I Notice D'emploi Et D'entretien

ENGLISH

Description and operation

The product you have purchased is a flush-fitting
centrifugal extractor fan for wall or ceiling installation
(all models) or for fitting to a false ceiling or slab (I, I T
models only). It is used for the ventilation of rooms and
extraction into single ducts. All the models have an
IPX4-grade, spray protection, and are thus ideal for
installing in high-humidity environments.
LL Models:
The"LL" models have ball bearings motor that
guarantee at least 30,000 hours of silent, trouble-free
mechanical operation.
T (Timer) Models:
This models are equipped with a timer factory-set fora
minimum operating time of 3 minutes. The timer can
be adjuste to settings between approx. 3 and 20
minutes by means of the trimmer (see fig. 37).The
appliance switches on automatically a few seconds
after the light is switched on and continues to run for
the set time after the light is switched off.
T-HCS Model:
The appliance features a relative humidity sensor that
is factory set at 60%. When relative humidity exceeds
that level, the appliance automatically starts up. This
threshold setting can however be modified by the
installer to 4 levels: 60%, 70%, 80% and 90% (fig. 38).
The circuit is also equipped with a timer that can be
adjusted to settings between approx. 3 and 20
minutes by means of the trimmer (see fig. 38). The unit
switches on automatically a few seconds after the light
is switched on and continues to run for the preset
period of time after the light is switched off.
6

Safety

Warning:
this symbol indicates that care must
be taken to avoid injury to the user
• Do not use this appliance for functions other than
those described in this booklet
• After removing the appliance from its packaging,
ensure that it is complete and undamaged. If in
doubt contact a professionally qualified electrician or
Vortice. Do not leave packaging within the reach of
children or infirm persons
• Certain fundamental rules must be observed when
using any electrical appliance, including:
- never touch electrical appliances with wet or damp
hands;
- never touch appliances while barefoot;
- never allow children or infirm persons to operate
appliances unattended.
• This appliance is not suitable for use by children or by
individuals with reduced physical, sensorial or mental
capacities, or by inexperienced or untrained
individuals, unless they are supervised or instructed
in its use by a person responsible for their safety
Children must always be supervised to ensure that
they do not play with the appliance.
• Store the appliance out of the reach of children and
differently able persons after deciding to disconnect
it from the power supply and use it no more.
• Do not us the appliance where flammable vapours
are present (spirit, insecticides, petrol, etc.).
Caution:
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not place objects on top of the appliance.
• Regularly inspect the appliance for visible defects. If
the appliance does not function correctly, do not use
it and contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately and
ensure that only genuine original Vortice spares are
used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice
• The appliance must be installed by a professionally
qualified electrician
• The mains power supply to which the units are
connected must comply with current laws.
• The appliance is double insulated and therefore
does not need to be earthed
• The electrical power supply/socket to which the
appliance is to be connected must be able to provide
the maximum electrical power required by the
appliance
• Use a suitably sized multi-polar switch with minimum
contact gaps of 3 mm to install the appliance.