Grillo G Z2 Manuel D'utilisation page 11

PROCEDURE
Engine oil
check the level
Air filter
Gearbox oil
Check the level
Check that the engine intake grid is
clean
Check that tines are well-sharpened
and well-fixed
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
LONG PERIODS OF STORAGE
If the machine is to be out of use for more than 30 days, drain the fuel from the engine to prevent
sticky deposits from forming in the fuel intake system or in vital parts of carburettor. To avoid this
procedure, it is possible to save fuel in storage up to 12 months by using an appropriate fuel
stabilizer. Add the such additive to the fuel in the tank or in the fuel container. Run the engine for a
while to let the stabilizer get into the fuel system. Important: if the engine is fed with petrol
containing alcohol, drain the fuel tank and run the engine until there is no fuel left.
TRANSPORTING THE MACHINE
If the tiller has to be transported on a lorry or a trailer, fasten it to the vehicle using ropes or cables.
FURROWER
The furrower (fig. 12) has been developed to perform both seed and irrigation furrows. It has to be
fitted at the place of the spur and it works together with the rotary tiller.
TILLER EXTENSIONS
The G Z2 tiller can be equipped with a tiller extension kit to increase working width up to 800 mm
(side discs included). This kit can be mounted to replace the tiller and shorten therefore the
working width (350 mm side discs included). IMPORTANT: always firmly tighten the fixing screws.
G Z2-G Z3/ Translation of the original instructions
MAINTENANCE SUMMARY TABLE
EVERY 8
HOURS
change (after the first
5 hours)
check
replace
replace
IMPLEMENTS
AFTER 20
HOURS
●
●
●
●
●
8
EVERY 50 EVERY 100
HOURS HOURS
●
●
●
●
●