9. Trouble shooting
Problem
Engine does not start
Abnormal noise level
Abnormal vibrations
Bad results
10. Specifications
Model
Power supply
Watt
Work width
Max. work debth
dB(A)
Grease
Reason
No power
Defective safety switch
Overheat protection active
Blades are blocked
Lack of grease
Loose bolts, nuts or safety
equipment.
Blades broken or worn
Work depth too big
Work depth too low
Worn blades
16
Solution
Check power and cables
Contact local dealer
a. Work at lower depth.
b. Remove possible blockages.
c. The soil is too hard. Change the
work depth and go slowly forwards
and backwards several times. Do
not restart for 15 min.
Stop the engine and await com-
plete stop. Remove the blockage.
Contact local dealer
Tighten. Contact local dealer, if
noise persists.
Replace or contact local dealer
Use correct work depth.
Use correct work depth.
Replace or contact local dealer
El-Tex 750
230 Volt - 50 Hz
750 Watt
30 cm
22 cm
93 dB(A)
Multifak EP-0 / 90306515