Trouble Shooting; Specifications - Texas A/S El-Tex 1000 Manuel D'utilisation

9. Trouble shooting

Problem
Engine does not start
Abnormal noise level
Abnormal vibrations
Bad results

10. Specifications

Model
Power supply
Watt
Work width
Max. work debth
dB(A)
rease
Reason
No power
Defective safety switch
Overheat protection active
Blades are blocked
Lack of grease
Loose bolts, nuts or safety
equipment.
Blades broken or worn
Work depth too big
Work depth too low
Worn blades
17
Solution
Check power and cables
Contact local dealer
a. Work at lower depth.
b. Remove possible blockages.
c. The soil is too hard. Change the
work depth and go slowly forwards
and backwards several times. Do
not restart for 15 min.
Stop the engine and await com-
plete stop. Remove the blockage.
Contact local dealer
Tighten. Contact local dealer, if
noise persists.
Replace or contact local dealer
Use correct work depth.
Use correct work depth.
Replace or contact local dealer
El-Tex 1000
230 Volt - 50 Hz
1000 Watt
280 mm
220 mm
93 dB(A)
Multifak EP-0 / 90306515