Scope Of Delivery/Design; Preparation For Wall Or Ceiling Installation (Surface Mounted); Installation - Helios MiniVent M1/100 Notice De Montage Et D'utilisation

Installation and Operation Instructions
UK
ATTENTION
CHAPTER 6

INSTALLATION

WARNING
MiniVent M1/100/120
All subsequent information and instructions are intended solely for
authorised electricians!
6.0

Scope of delivery/Design

Leave the delivery unit in its box until installation. Check that the fan is in good condition and has not been damaged
in transit.
MiniVent M1/100/120..
˜
—
–
6.1

Preparation for wall or ceiling installation (surface mounted)

The safety instructions in chapter 1.2 must be observed!
The fan is delivered as a complete unit, i.e. ready for connection, as standard. The installation and start-up of the fan
should take place after the completion of all other works and after the final cleaning, in order to prevent damage and
contamination of the ventilation unit.
After the removal of packaging and the start of installation, the following points must be checked:
– is there any transport damage,
– broken or bent parts
– freewheeling of the impeller
6.2 Installation
The M1/100/120 MiniVent is designed for direct wall installation. The housing must not be deformed or warped du-
ring installation, and the flat structure of the installation surface must be ensured. The fans must only be installed on
sufficiently solid and stable subsurfaces with suitable fastening materials. Sufficient backflow must be ensured! If ap-
plicable, observe instructions in DIN 1946-6.
1. Cable exit from the wall:
– The location of the cable outlet varies in the dark area (fig.6).
– Distance to the duct centre depending on cable exit 58/68* mm with a variable position under the casing.
– For a simple assembly an exit is recommended as shown (turnable by 90° in each case).
The optimal position is 45° each if the cable exit is directly at the position of the cable grommet.
fig.5
–
Facia
—
Terminal compartment cover
›
incl. 2x fastening screws
˜
Control board
™
Plastic casing with impeller
š
Guide vane removable at reduced installation depth
›
Back draught shutter removable
š
œ
Cable grommet

Assembly kit
œ
2x screws including plugs for wall mounting
™

6