TFA 31.5006 Mode D'emploi page 7

TFA_No. 31.5006_Anl_10_14
AIRCO NTROL MINI CO
2
4. For your safety
• This product is exclusively intended for the field of
application described above. It should only be used
as described within these instructions.
• Unauthorized repairs, modifications or changes to
the product are prohibited.
Caution!
Risk of electrocution!
• Connect the device only to a standard USB port or
plug it by means of an external AC/DC adapter in a
socket installed according to directions and with a
mains voltage of 230V! Otherwise your device may
be damaged.
• The device and the USB cable must not come into
contact with water or moisture. It should be operat-
ed in dry interiors.
• Do not use the device if the housing or the USB
cable are damaged.
• Keep the device out of reach of persons (including
children) who cannot fully appreciate the potential
risks of handling electrical equipment.
• Disconnect the power supply if any fault occurs or if
the device is not used for a long period of time.
• Only use the supplied USB cable
• Route the USB cable lead so that it does not come
into contact with sharp-edged or hot objects.
Important information
on product safety!
• Do not place your product near extreme tempera-
tures, vibrations or shocks.
• To avoid damage to the electronics, do not remove
the protective cover and never insert sharp objects
into the ventilation slots.
12
17.10.2014 11:33 Uhr
Monitor
2
Seite 7
AIRCO NTROL MINI CO
2
EMC/RFI
• Protect the unit from EMI (Electro Magnetic Interfer-
ence) from induction heaters and microwave ovens
and Electro Static Discharge. Readings may be
affected if the unit is operated within a radio fre-
quency electromagnetic field strength of approxi-
mately 3 volts per meter, but the performance of the
instrument will not be permanently affected.
5. Elements
A: Indication of CO / indoor temperature
2
B: LED indicator lamps
C: Protective cover with ventilation slots
D: USB power inlet
E: Calibration hole *
* only important for calibration during production.
Please do not insert sharp objects.
6. Getting started
• Use the supplied USB cable for power supply. Con-
nect the device for power supply to a standard USB
port (for example PC) or use a suitable AC/DC
adapter with an output voltage of DC 5V.
• All LCD segments will be displayed for about a few
seconds.
• On the display appear the numbers five until one.
• The unit is ready for use.
• The display will change automatically between the
CO concentration and the actual measured tem-
2
perature (15 sec., 5 sec.).
7. LED indicator lamps
• Optimum air quality:
The CO concentration is below 800 ppm. The
2
green warning lamp lights up.
Monitor
2
13