Publicité
Les langues disponibles
Les langues disponibles
1
2
3
008047
1
3
008048
Installing or removing wheel guard
CAUTION:
When
using
a
•
wheel/Multi-disc, wire wheel brush or cut-off wheel,
the wheel guard must be fitted on the tool so that
the closed side of the guard always points toward
the operator.
For tool with locking screw type wheel guard
007994
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure
in reverse.
1. Loop handle
2. Hex wrench
3. Bolt
1. Loop handle
2. Bolt
3. Hex wrench
2
depressed
center
grinding
1. Wheel guard
2. Screw
3. Bearing box
1
2
3
For tool with clamp lever type wheel guard
1
008343
1
008344
Loosen the lever on the wheel guard after loosening the
screw. Mount the wheel guard with the protrusion on the
wheel guard band aligned with the notch on the bearing
box. Then rotate the wheel guard around to the position
shown in the figure. Tighten the lever to fasten the wheel
guard. If the lever is too tight or too loose to fasten the
wheel guard, loosen or tighten the screw to adjust the
tightening of the wheel guard band.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
WARNING:
Always use supplied guard when depressed center
•
grinding wheel/Multi-disc is on tool. Wheel can
shatter during use and guard helps to reduce
chances of personal injury.
007995
6
1. Bearing box
2
2. Wheel guard
3. Screw
4. Lever
3
4
1. Screw
1. Lock nut
1
2. Depressed
2
center grinding
wheel/Multi-disc
3
3. Inner flange
Publicité
