Publicité
Les langues disponibles
Les langues disponibles
CHANNEL CONTROL SECTION
1. CH 1 Gain Control: Use this knob to adjust the gain of
LINE 1 input signal
2. CH 1 Treble Control: Use this knob to adjust the treble of
LINE 1 input signal
3. CH 1 Bass control: Use this knob to adjust the bass of the
LINE 1 input signal
4. MIC VOL: Use this knob to adjust the volume of the
microphone volume
5. USB Input: Connect the USB here
6. USB/Bluetooth & Line Selector: Press the selector to
switch the input between USB/Bluetooth and Line input.
7. CH 2 Gain Control: Use this knob to adjust the gain of
LINE 2 input signal
8. CH 2 Treble: Use this knob to adjust the treble of LINE 2
input signal
9. CH 2 Bass Control: Use this knob to adjust the bass of the
LINE 2 input signal
10. Headphone Vol: Use this knob to adjust the volume of headphone output
11. Master VOL: Use this knob to adjust the master volume
12. Line signal selector: Set the selector to the left side to mute the CH2 input signal and set the selector
to the right side to mute the CH 1 input signal. If the selector is in the middle position, both CH 1 input
signal & CH 2 input signal will be mixed and sent to OUTPUT Jacks.
REAR PANEL CONTROLS:
1. 12V Power supply: Connect the adapter
here
2. Master output: Connect this output to the
RCA input of an amplifier or active speaker
3. REC output: Connect this output to the RCA
input of a tape recorder, amplifier or active
speaker.
4. Line 2 input: Connect the Line 2 Signal here.
This is CH 2 signal.
5. Line 1 input: Connect the Line 1 signal here.
This is CH 1 signal.
CONTROLS
1. MIC input: Connect the microphone here
2. USB/Bluetooth Selector: Press this button
to switch the input between USB &
Bluetooth.
3. Play/Pause: Press this button to play the
signal from USB & Bluetooth. Press again to
©Copyright LOTRONIC 2016
MIX500BT
3
Publicité
