Philips HR1942 Mode D'emploi page 7

Masquer les pouces Voir aussi pour HR1942:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
Before first use
Thoroughly clean all parts before you use the appliance for the first time (see
chapter 'Cleaning').
Note: Make sure all parts are completely dry before you start using the appliance.
Preparing for use
Assembling the juicing unit
1
Attach the pulp outlet to the juicing unit and turn it clockwise until the arrow
(
) points to the 'locked' indication. (Fig. 2)
2
Insert the juicing screw into the juicing unit (Fig. 3).
3
Assemble the two parts of the filter (Fig. 4).
4
Place the two-part filter over the juicing screw (Fig. 5).
Tip: Use the black two-part filter for clear juice. If you prefer cloudy juice with
more fibres in it, use the grey two-part filter.
5
Attach the spout to the juicing unit and turn it clockwise until the arrow (
points to the 'locked' indication. (Fig. 6)
Important: Do not attach or detach the spout when the juicing unit is mounted on
the motor unit. Always take off the juicing unit from the motor unit before
assembling or disassembling.
6
Place the berry tray on the feeding tube (Fig. 7).
Placing the juicing unit onto the motor unit
1
Place the assembled juicing unit onto the motor unit, with the pulp outlet
fitting into the opening on the motor unit (Fig. 8).
2
Align the projections on the juicing unit with the recesses in the motor unit.
Slide the juicing unit onto the motor unit until it locks into place. (Fig. 9)
3
Press the juicing unit onto the motor unit (1) and then close the locking clamp
(2). (Fig. 10)
Note: If the locking clamp cannot be closed, check if the juicing unit is positioned
properly with the projections on the juicing unit into the recesses of the motor
unit.
4
Slide the pulp container into the motor unit (Fig. 11).
Using the appliance
The appliance only functions if the juicing unit and the pulp outlet are
assembled correctly and the locking clamp is locked properly.
1
Wash the fruit and/or vegetables. If necessary, cut them into pieces that fit into
the feeding tube.
Note: Remove stones and thick peels of the fruits you would not eat, for example
from oranges, pomegranates etc.
2
Place a jug or a glass under the spout (Fig. 12).
3
Press the on/off button to switch on the appliance (Fig. 13).
ENGLISH
9
)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hr1943Hr1944Hr1945Hr1946Hr1947Hr1949

Table des Matières