ECOVACS ROBOTICS Deebot N79SE Manuel De L'utilisateur page 26

5. Troubleshooting
No. Malfunction
DEEBOT will not
4 clean automatically at
scheduled time.
Remote Control failure
(effective control range
5
of Remote Control is
5m (16').
24
EN
Possible Causes
Time Scheduling function is
cancelled.
DEEBOT is powered OFF.
The robot's battery is low.
The robot's components are
tangled with debris.
The batteries in the Remote
Control need to be replaced.
DEEBOT is powered OFF or
DEEBOT's battery is low.
The infrared signal cannot
be transmitted because
the Infrared Emitter on
the Remote Control or
DEEBOT's Infrared Receiver
on DEEBOT is dirty.
There is other equipment
interfering with the infrared
signal to DEEBOT.
Solutions
Set Time Scheduling function as
described in section 3.4.
Power ON DEEBOT.
Keep DEEBOT powered ON and on
the Charging Dock to make sure it has
a full battery to work at any time.
Power OFF DEEBOT, clean the
Dust Bin, and invert the robot. Clean
Side Brushes and the Main Brush as
described in section 4.
Replace with new batteries making
sure they are installed correctly.
Make sure DEEBOT is powered ON
and fully charged.
Use a dry cloth or the Multi-Function
Cleaning Tool to wipe the Infrared
Emitter on Remote Control and the
Infrared Receiver on DEEBOT.
Avoid using the Remote Control near
other equipment using infrared signals.