Publicité
Les langues disponibles
Les langues disponibles
EN
HORIZONTAL USE
In order to set a second gradient (i. e. paving works) also the Y axis can be tilted manually. The ope-
ration is made with the buttons (12) / (13) of the remote control.
If the Y axis has been tiled manually the LED (2) of the laser will light green permanently.
To quit these slope functions power off the laser first and then power on again.
VERTICAL USE
·
Unfold the datum point on the integrated floor mount and set up the laser in its vertical (lay-down)
position.
·
The laser automatically self-levels in this position.
·
Set the ciruclar bubble as accurately as possible by using the two thumb screws. This ensures that
the instrument is set within its self-levelling range and the rotating beam is centered over its datum
point.
VERTICAL AXIS DIRECTION IN Y-AXIS WITH REMOTE CONTROL (12 + 13)
The direction of the Y-axis can be set manually up to 5°, the second axis remains self-levelled.
In vertical direction a slope setting is not possible.
The axis direction is to be set with the buttons (12) / (13) of the remote control.
If the Y axis has been shifted the LED (2) of the laser will light green permanently.
To quit the axis direction function bring the laser in a horizontal position and power off the laser first
and then power on again.
When the self-levelling procedure is completed the TILT function is automtically active, the V-W-S
function can be activated.
ON / OFF REMOTE CONTROL FUNCTION (9)
With this button the remote control can be powered off - but not the instrument.
Press the ON/OFF button of the remote; the instrument will be in standby function. The ON/OFF
LED of the laser flashes. The values set will remain.
If the batteries of the remote are empty each key pressure will cause a permanent sound.
LED REMOTE CONTROL (10)
This LED flashes if any button is used and a beep sounds.
TILT FUNCTION (11)
See top of page 27.
With the remote control only the Y axis can be set.
28
Publicité
