InnoCigs EXCEED D22 Manuel D'utilisation page 41

INNOCIGS EXCEED D22 – USING THE DEVICE
Adjusting the Air Supply
By gently turning the airflow control ring on the top cap, you can increase or decrease the air supply according
to your personal preference. The more air flows through the device (the more the slots are open), the lower is
the drawing resistance. Pay particular attention to a sufficient air supply during sub-ohm vaping.
Attaching or changing the mouthpiece
The mouthpiece is attached to the cap on top of the clearomizer. The mouthpiece may be cleaned with warm
water. Make sure that it is completely dry before reinserting into the clearomizer.
39