ATIKA ASP 6-1050 Instructions D'utilisation page 20

2. Place the log on the log splitter table.
Only split the logs in the direction of the wood fibres.
8
3. Hold the log tight with the clamping claws.
4. Press both operating handles down simultaneously:
The splitting blade falls down and splits the log.
5. Release the two control handles, the splitting blade
returns to its initial position.
If you only release one control handle, then the
splitting blade remains where it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum
dimensions. Ensure also that the logs are cut straight and
square.
Place the log properly on the log splitter, so as not to cause
any risk of stumbling or falling to the operator.
Adjusting the stroke height
In case of shorter wood pieces the efficiency can be
increased by shortening the return of the splitting cutter.
1. Place the log on
the splitting table
and press the two
control handles to
bring the splitting
blade down to
approx. 2 cm
above the log.
2. Release one
control handle so
that the blade stays
in this position.
3. Switch the machine
off and disconnect
the power.
10
4. Release the second control handle.
5. Shorten the return path at the rod fitted to the side by
fixing the holding screw at the necessary height.
Adjusting the table height
Upper table
position for logs up to
590 mm
Middle table
position for logs up to
780 mm
Lower table
position for logs up to
9
1040 mm
Holding screw
plate
plate
plate
11
12
19