EUROM Nordic Manuel D'utilisation page 29

Operating
 Check that the details on the data plate correspond to those of the electrical
supply which you wish to use for the fireplace. Do not use the same connection
for any other equipment.
 The control switches and the thermostat knob are located at the rear of the
heater.
 By pressing the bottom switches you will make the following happen:
Switch 1:
Switches 1+2: s
Switches 1+2+3:
 Check whether switch 1 is set to OFF (O depressed)
 Connect the plug to an earthed power outlet.
 Turn the thermostat dial to maximum (clockwise as far as possible).
 Press switch 1 and, depending on what you want, switches 2 and 3 to start using
the heater.
 Once the desired temperature is reached, turn the thermostat dial back slowly
until you hear a click. The temperature is now set. The heater will automatically
switch on and off to maintain the set temperature. To set a higher or lower
temperature, turn the thermostat dial either clockwise or anticlockwise.
 Switch off the heater by resetting all switches to the OFF position. Remove the
plug from the power outlet; do this whenever the heater is not in use!
Safeguards
The Nordic Fireplace atmospheric fireplace is equipped with an overheating
safeguard. The overheating safeguard switches the heater off if it overheats
internally. This may occur if the heater cannot give off enough heat or if it cannot
draw in enough fresh air. As mentioned above, this is generally caused by
(partially) covering the heater, obstructing the air intake and/or outlet grills or
installing the heater too close to a wall or something similar.
switch on the power supply to the heater and the flame
effect (without heating) (O depressed is OFF - I depressed
is ON).
witch on 1000 Watt heating, with flame effect
switch on 2000 Watt heating, with flame effect
29