Mounting The Hood - Zephyr Tidal I AK7300AS Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Mounting the Hood

If recirculating range hood refer to the manual included with ZRC-70xxC recirculating kit or on our
website prior to installing hood.
Hood is designed for installation under a kitchen
cabinet.
1. Prepare duct location on hood (vertical or
horizontal).
2. Begin installation by removing the safety screw
on top of hood body and filters. Then remove
side panels by (2) screws.
3. Reinforce cabinet with 1" x 2" wood strips
if additional strengthening is required or if
cabinets are framed.
4. Temporarily position the range hood in the
desired mounting location. Measure and
mark the mounting holes, duct and electrical
locations with a pencil.
5. Drill/cut out the required openings for duct and
electrical access; make sure the duct opening
is large enough to apply duct tape.
6. Fasten hood onto cabinet with (4) M4 wood
screws provided.
7. Install electrical.
8. Install duct work and seal with duct tape.
9. If using RF remote control, remove the light
panel by (4) screws and extend the blue
antenna wire. There is no need to secure it.
Reinstall light panel.
10. Reinstall the filters and side panels.
11. Power up hood and check for leaks around
duct tape.
20
FIG. B
Tidal I Use, Care, and Installation Guide
P R O
T I D A L I
U N D E R - C A B I N E T
Electrical
Duct
opening/
cutout
Aluminum duct
tape
Add 1" x 2"
wood strips
Pro baffle filters