Chicco Balloon Mode D'emploi page 12

Masquer les pouces Voir aussi pour Balloon:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
child to climb or causing chocking
or strangling hazards.
• D o not place the chair near windows
or walls to prevent the risk for the
child of overreaching and falling over.
• D o not attach any strings to ex-
tend the fastening systems of the
toybar's hanging toy and do not
make knots/ loops: This could lead
to running knots from accidentally
forming which could lead to stran-
gulation.
• WARNING: This toy must only be
used under adult supervision.
• WARNING: Check the product
regularly for signs of wear and
damage and to ensure that it is
assembled correctly. Should any
parts on the toybar or hanging toy
be damaged, do not use them and
keep out of reach of children.
• K eep the product out of children's
reach when it is not being used.
CARE AND MAINTENANCE
FABRIC COMPOSITION
COVER:
Outer cover: 100% polyester. Padding: 100% polyurethane
BOOSTER CUSHION:
Outer cover: 100% Polyester. Padding: 100% Polyester.
• This product requires periodical maintenance.
• T he cleaning and maintenance operations must only be carried
out by an adult.
• P eriodically inspect the reclined cradle to check for broken, torn or
missing parts: If this is the case, do not use it.
• P lease refer to the care label for instructions on cleaning the swing.
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
• C heck that the fabric and stitching are in good condition each time
you wash it.
• P rolonged exposure to direct sun light can cause the fabric colours
to fade.
COMPONENTS
Components
A - Base
B - Feet
B1 - Non-slip rubber
B2 - Open/close buttons
C - Seat
D - Booster cushion
DD - Headrest
E - Toybar
E1 - Sound toy release button
F - Removable sound toy
G - Toys
H - Toybar coupling slot
I - Fabric handles
I1 - Strap for the sound toy fastening
L - Safety harness
M - Buckles
N - Clips
O - Ring for the adjustment of the safety harness
P - Reclining button
Q - Click buttons
R - Vibration box
S - Seat buttonhole
ASSEMBLY
The reclined cradle comes already assembled. To use it, the follow-
ing operations must be performed:
1. T o open the reclined cradle pull the seat upward (Fig. 1), when
you hear it click, it means the product is correctly opened. Make
sure that both sides of the reclined cradle are properly open.
2. F asten the toy bar inserting the lower ends of the toybar in the
relevant fastening hole (Fig. 2).
HOW TO ADJUST THE BACKREST
3. T o adjust the backrest from a higher position to a more inclined
one, take the two side buttons (Fig. 3) and pull them upward,
keeping them pressed down; choose the desired reclining within
the 4 available positions. This operation may also be carried out
with the child sitting in the reclined cradle. In this case it can be
more difficult.
WARNING: Always guide the backrest with the fingers when ad-
justing the reclining.
To move from the most inclined position to a less inclined position,
just pull the backrest up (Fig. 4-5).
WARNING: Always check that the backrest is properly locked before use.
The reclined cradle is equipped with transport handles made of fabric.
WARNING: The transport handles (I), when not used, shall be fixed
on the back of the backrest with the velcro ribbons.
FIXED OR ROCKING MODE
4. T he reclined cradle can be used in fixed or rocking mode:
- F ixed mode: turn the front feet (B) forward until the lower part of
the foot touches the ground (Fig. 6);
- R ocking mode: turn the front feet (B) in the opposite direction, so
that the foot is not touching the ground (Fig. 7).
HOW TO CLOSE THE CHAIR
5. The reclined cradle can be closed for transport.
WARNING: The reclined cradle must never be closed with the child
sitting in it. Remove the child from the reclined cradle before clos-
ing the frame!
6. T o close the reclined cradle, press the 2 buttons inside the front
feet (Fig. 8) simultaneously.
7. T o open the reclined cradle again, just pull the seat upward (Fig. 9)
until you hear a click that indicates the correct opening.
USING THE SAFETY HARNESS
8. W hen using the safety harness for the first time, they are already
fitted (Fig. 10).
To release them, press the toothed ends of the clasp and remove
the two clasps (Fig. 11). The reclined cradle is ready for the child.
WARNING: When using, always fasten the belts inserting them in
the crotch strap and check they are tight enough and in the right
position.
12
9. K
a
s
BO
10
TO
11
WA
be
slig
(Fig
12
WA
• T o
m
th
p
b
fo
Bo
• B a
• O
ty
b
• M
• N
• A
• D
• A
p
• A
lo
• R
d
• D
m
• I f
in
h
• A
b
• D
• T h
m
• I f
re
• D
w
• R e
RE
Th
by
F1
F2
F3
F4
F5
F6
F7
For
Ke
vo

Publicité

Table des Matières
loading

Table des Matières