Publicité
Les langues disponibles
Les langues disponibles
gb
Power tools are designed for tightening and loosening
screws, for drilling in wood, metal, ceramic and
plastic, and impact drilling in brick, concrete and
stone.
1_SPECIFIC SAFETY INSTRUCTIONS
Hold power tool by insulated gripping surfaces, when
performing an operation where the fastener may
contact hidden wiring. Fasteners contacting a "live"
wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam
and lead to loss of control over the power tool.
Do not open the battery. Danger of short-circuiting.
Protect the battery against heat, e. g., against
continuous intense sunlight, fire, water, and moisture.
Danger of explosion.
In case of damage and improper use
of the battery, vapours may be emitted.
Provide for fresh air and seek medical help in case of
complaints. The vapours can irritate the respiratory
system.
Use the battery only in conjunction with your STAYER
power tool. This measure alone protects the battery
against dangerous overload.
Use only original STAYER batteries with the voltage
listed on the nameplate of your power tool. When
using other batteries, e. g. imitations, reconditioned
batteries or other brands, there is danger of injury as
well as property damage through exploding batteries.
2_INSTRUCTIONS FOR USE
PLACEMENT TOOL
Read all safety warnings and all instructions. Failure to
follow the warnings andinstructions may result in
electric shock, fire and/or serious injury.
ASSEMBLY
Do not continue to press the On/Off switch
after the machine has been automatically
switched off.
- The battery can be damaged..
To remove the battery 5 press the unlocking buttonsv
9 and pull out the battery downwards. Do not exert
any force.
The battery is equipped with a temperature control
which allows charging only within a temperature
range of between 0 °C and 45 °C. A long battery
service life is achieved in this manner.
Observe the notes for disposal.
ELECTRICAL CONNECTION
Battery Charging
Use only the battery chargers listed on the accessories
page. Only these battery chargers are matched to the
lithium ion battery of your power tool.
The battery is supplied partially charged. To
ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the first time.
The lithium-ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The lithium-ion battery is protected against deep
discharging. When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted
tool no longer rotates.
Charge status indicator
The charging status indicator 10 of the magazine, is
composed of two LEDs:
Green: Displayed when the battery is charged.
Red: Displayed when the battery is charging.
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot
be subject to overload. When the load is too high or
the allowable battery temperature range of 0–50 °C
is exceeded, the speed is reduced. The power tool
will not run at full speed until reaching the allowable
battery temperature.
ILUSTRATED DESCRIPTION
1 Screwdriver bit
2 Tool holder
3 Ring preset torque setting for
4 Speed selector
5 Battery
6 Bulb
7 On/Off switch
8 Rotational direction switch
9 Battery unlocking button
10 Battery charge-control indicator
11 Charger
3_OPERATING INSTRUCTIONS
START
Use only original Stayer lithium ion batteries with
the voltage listed on the nameplate of your power
tool. Using other batteries can lead to injuries and
/
/
12
Publicité
