Publicité
Les langues disponibles
Les langues disponibles
•
Do not use abrasive products, abrasive cleaning
pads or solvents.
INTERNAL CLEANING
•
Carefully clean the appliance, including the
rubber gasket of the door, with a soft damp
cloth.
•
If you regularly use short duration programmes,
these can leave deposits of grease and
TROUBLESHOOTING
If the appliance does not start or it stops during
operation, first check if you can solve the problem
by yourself with the help of the information in the
table or contact an Authorised Service Centre.
WARNING! Repairs not properly done
may result in serious risk to the safety
of the user. Any repairs must be
performed by qualified personnel.
Problem and alarm code
You cannot activate the appli-
ance.
The program does not start.
The appliance does not fill with
water.
The display shows
.
The appliance does not drain
the water.
The display shows
The anti-flood device is on.
The display shows
The appliance stops and starts
more times during operation.
•
Make sure that the mains plug is connected to the mains sock-
et.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of
the countdown.
•
The appliance has started the procedure to recharge the resin
inside the water softener. The duration of the procedure is ap-
proximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
or
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clogged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the filter in the outlet hose is not clogged.
•
Make sure that the interior filter system is not clogged.
.
•
Make sure that the drain hose has no kinks or bends.
•
Close the water tap and contact an Authorised Service Centre.
.
•
It is normal. It provides optimal cleaning results and energy sav-
ings.
limescale inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per month.
•
To maintain the performance of your appliance
at its best, we recommend to use monthly a
specific cleaning product for dishwashers.
Follow carefully the instructions on the
packaging of the product.
With some problems, the display shows an
alarm code.
The majority of problems that can occur can
be solved without the need to contact an
Authorised Service Centre.
Possible cause and solution
29
Publicité
