brennenstuhl BR 1201 Mode D'emploi page 19

052609 Rauchwarnmelder BR 1201-0_052609 Rauchwarnmelder
BR 1201
Roof peak
Installation and set-up of smoke alarm
NOTE: The enclosed mounting equipment is
suitable for concrete slabs. For other subsurfaces,
suitable mounting equipment should be purchased
from a specialty shop.
NOTE: An alarm can simply be stopped by
removing the battery from the battery clip.
The smoke alarm is powered by a battery and
needs no other electical power supply.
Operating Instructions
In areas with sloping and
peaked roofs, the smoke alarm
must be mounted 90 cm from
the highest peak, since air does
not move in the slope/point.
This results in the smoke being
detected too late.
Smoke
NOTE:
Mounting on a roof beam is ideal.
19