Before Using For The First Time; Electrical Connection - Bosch B0 IB Série Notice D'utilisation

Masquer les pouces Voir aussi pour B0 IB Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en-us Installation and connection
Using the appliance
Open the appliance door only briefly.
Transport purchased food in a cool bag and place in the appliance
quickly.
Let warm food and drinks cool down before placing them in the appli-
ance.
Place food to be defrosted in the cooling compartment in order to uti-
lize the low temperature of the frozen food.
Always leave a space between the food and to the back panel.
Pack food airtight.
Do not cover or block the ventilation openings.
Close the freezer compartment door carefully.
--------

Before using for the first time

Remove information material, adhesive tape and
1.
protective foil.
Clean the appliance.
2.
~ "Cleaning" on page 20

Electrical connection

9
CAUTION
Do not connect the appliance to electronic
energy saver plugs.
You can connect the appliance to mains-
Note:
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national
grid. Sine-controlled inverters must be used for
isolated applications. Isolated applications, e.g. on
ships or in mountain lodges, are not directly
connected to the national grid.
8
The air in the appliance does not warm up as intensely. The appliance
needs to cool less frequently and therefore consumes less power.
The air can circulate and the humidity will remain constant. The appli-
ance needs to cool less frequently and therefore consumes less
power.
The air on the back panel of the appliance does not warm up as
intensely. The appliance consumes less power if the warm air can
escape.
The freezer compartment will become covered in thick ice. If greater
demands are made of the appliance, the power consumption will
increase.
After installing the appliance, wait at least 1 hour
1.
before connecting it to prevent damaging the
compressor.
Check that the outlet was installed according to
2.
the regulations and complies with the
requirements.
Requirements for outlets
Outlet with
110 V ... 120 V
Protective
60 Hz
conductor
Fuse
10 A ... 16 A
Maximum simultaneous load
Appliance
6 A
Connect the appliance to an outlet near the
3.
appliance.
The outlet must also be freely accessible
following installation of the appliance.
9
WARNING
RISK OF ELECTRIC SHOCK!
Never use multiple outlets, extension cords
or adapters.
The appliance must be grounded correctly.
Never cut through or remove the power
cord's third conductor (grounding
conductor).
9
WARNING
RISK OF ELECTRIC SHOCK!
If the power cord is too short, never use
multiple outlets or extension cords. Instead,
please contact customer service.

Publicité

Table des Matières
loading

Table des Matières