Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Furniture door dimensions
Key
A
Furniture door protrusion
B
Lower edge of furniture door
Saving energy
If you follow the instructions below, your appliance will use less power.
Note:
The arrangement of the fittings does not affect the energy consumption of the appliance.
Installing the appliance
Keep the appliance out of direct sunlight.
Install the appliance as far away as possible from heating elements,
cooker and other heat sources:
1
/
" (3 cm) to electric or gas cookers
1
4
11
/
" (30 cm) to oil or solid fuel cookers
13
16
Select an installation location with a room temperature of approx.
68°F (20°C).
Use a cavity depth of 22
/
'' (56 cm).
3
64
9
CAUTION
Risk of burns!
Individual parts of the appliance become hot during operation.
Touching these parts may result in burns.
Do not cover or block the ventilation openings.
Ventilate the room daily.
Installation and connection en-us
The specified furniture door dimensions apply for a
door gap of
/
" (4 mm).
5
32
Niche dimensions
Cavity depth
A cavity depth of 22
/
3
for the appliance. If the cavity depth is smaller – at
least 21
/
'' (55 cm) – the energy consumption
21
32
increases slightly.
Niche width
An inside niche width of at least 22
required for the appliance. Any deviations from this
requirement may cause problems when installing the
appliance.
Side by side installation
It is only possible to install appliances side by side
with a gap of at least 5.9" (15 cm).
The appliance needs to cool less frequently at low ambient tempera-
tures and therefore consumes less power.
The air on the back panel of the appliance does not warm up as
intensely. The appliance consumes less power if the warm air can
escape.
'' (56 cm) is recommended
64
/
'' (56 cm) is
3
64
7
Publicité
Chapitres
Table des Matières
